SDS 200 Signals, squelch control

[teebee]

As the scanner is scanning sites on my new SDS200, the scanner stops on "every site" for a couple of seconds showing all 5 full signal bars. These site are out of signal reach for them to pickup signals. However the few sites that are in reach are picking up traffic as normal. This just started doing this earlier today. The only thing I did before this was went in the menu and looked up the ip settings for Proscan to operate. This is causing the scanner to scan much slower than normal because of stopping on all of the site.

Any ideas what's going on?

 

[teebee]

Nevermind, found my issue. Squelch was set to "0" Problem solved

 

[a417]

Nevermind, found my issue. Squelch was set to "0" Problem solved

was that also done today?

 

[Brales60]

Not hard to hit the squelch when going for the volume.

 

[trentbob]

Not hard to hit the squelch when going for the volume.

The dials are opposite on the BCD 536 LOL. Shrugs.

 

[teebee]

was that also done today?

Yes it was

 

[teebee]

Still trying to get used to the opposite knobs

 

[JoeBearcat]

Still trying to get used to the opposite knobs

I'm still trying to get used to the fact they were moved from the left side to the right side on the 536.......