Turned on my sds100 and changed the zip code back to my home county since I took it on a trip and when I did, it loaded up a county next to me and stayed on that county and one channel but not scanning. Very weird. Turned it off and back on and loaded my zip and it worked normal. All services were on as usual. Tried selecting the county it was stuck on seeing if it would scan, but it unhighlighted the county and stayed on that one frequency. Maybe an sd card issue??
SDS100/SDS200: SDS100 zip code issue
- Thread starter scannerman200
- Start date
- Status
is range set to 0.0 miles?
i've had a weird issue before where a 536 would lock up on a single channel from the next county over, which had traffic on a CTCSS code different then was programmed in the scanner. It wasnt strong enough to break squelch, but it was strong enough to make the scanner stick on the channel. Setting range to 0.0 resolved it, but if it was on anything else including 0.5 miles it would do that.
i've had a weird issue before where a 536 would lock up on a single channel from the next county over, which had traffic on a CTCSS code different then was programmed in the scanner. It wasnt strong enough to break squelch, but it was strong enough to make the scanner stick on the channel. Setting range to 0.0 resolved it, but if it was on anything else including 0.5 miles it would do that.
I think it was on 0, but when I set the zip code it automatically changed to 10 miles
- Status
Similar threads
SDS100/SDS200:
Sentinel issue