I need some help with DMR scanner programming.
I have SDS200 with DMR upgrade.
I am trying to scan Dee Bus Company.
According to fcc.gov/uls, I found WQXG423
They have 2 frequencies, 463.55 and 468.55.
Dee has 2 locations, Shirley, MA and Townsend, MA
Both locations use the same frequency pair.
463.55 is the repeater output, so I use this.
I am located between both locations and I have good signal strength.
I looked at other forums and scanned the frequencies using conventional.
It shows up as Color Code 13, Cap+ and mostly Slot 1.
Sometimes I see it alternating from Slot 1 to Slot 2 quickly.
I setup a Favorites List just for DMR scanning.
I setup one sublist for "Conventional," another one for "DMR One Frequency" and another one for "MotoTRBO Trunk"
On the Conventional, I would hear the digital noise sometimes and then it would catch a conversation.
I wrote down many UID numbers.
For DMR One Frequency:
I programmed in all the Unit IDs under the tab in Sentinel software.
TGID = 0 (Default from software)
TDMA Slot = Any (I have tried it as Slot 1 and Slot 2 also)
Sites = 463.55 using Color Code 13 (I also tried this as Search for Color Code)
ID Search = On
Nothing is ever heard on this, even when locked on for days.
For MotoTRBO Trunk:
Same settings and UIDs programmed, but also set LCN = 1 since I heard nothing on the default LCN of 0.
I have tried setting this Color Code to "Color Code Search"
Nothing is ever heard on this, even when locked on for days.
Does anyone have any suggestions, because Conventional doesn't seem to work all the time?
Thank you for any suggestions you can provide.
I have SDS200 with DMR upgrade.
I am trying to scan Dee Bus Company.
According to fcc.gov/uls, I found WQXG423
They have 2 frequencies, 463.55 and 468.55.
Dee has 2 locations, Shirley, MA and Townsend, MA
Both locations use the same frequency pair.
463.55 is the repeater output, so I use this.
I am located between both locations and I have good signal strength.
I looked at other forums and scanned the frequencies using conventional.
It shows up as Color Code 13, Cap+ and mostly Slot 1.
Sometimes I see it alternating from Slot 1 to Slot 2 quickly.
I setup a Favorites List just for DMR scanning.
I setup one sublist for "Conventional," another one for "DMR One Frequency" and another one for "MotoTRBO Trunk"
On the Conventional, I would hear the digital noise sometimes and then it would catch a conversation.
I wrote down many UID numbers.
For DMR One Frequency:
I programmed in all the Unit IDs under the tab in Sentinel software.
TGID = 0 (Default from software)
TDMA Slot = Any (I have tried it as Slot 1 and Slot 2 also)
Sites = 463.55 using Color Code 13 (I also tried this as Search for Color Code)
ID Search = On
Nothing is ever heard on this, even when locked on for days.
For MotoTRBO Trunk:
Same settings and UIDs programmed, but also set LCN = 1 since I heard nothing on the default LCN of 0.
I have tried setting this Color Code to "Color Code Search"
Nothing is ever heard on this, even when locked on for days.
Does anyone have any suggestions, because Conventional doesn't seem to work all the time?
Thank you for any suggestions you can provide.