- Joined
- Apr 27, 2005
- Messages
- 61
Good Evening,
I finally broke down and picked up the new 436. Very quick start up and was up and running in about 5 minutes. Except for the Michigan's system which had a control channel change about 3 months ago. (which my database is from 09-13). I installed Sentinel (v1.02) and attempted to update the database. It keeps having the error: Unable to connect to remote server
After doing some searching it appears this is not an uncommon problem. I have tried:
1. Uninstall and reinstall of Sentinel 3 times
2. Turned off firewall on computer
3. Restarted network and computer
4. Switched over to a second network (different company) and tried
and none of these have worked so far. I tried going to the Uniden site listed in the manual and that the requested document not found on the server.
Any suggestions?
Thanks,
Bob
I finally broke down and picked up the new 436. Very quick start up and was up and running in about 5 minutes. Except for the Michigan's system which had a control channel change about 3 months ago. (which my database is from 09-13). I installed Sentinel (v1.02) and attempted to update the database. It keeps having the error: Unable to connect to remote server
After doing some searching it appears this is not an uncommon problem. I have tried:
1. Uninstall and reinstall of Sentinel 3 times
2. Turned off firewall on computer
3. Restarted network and computer
4. Switched over to a second network (different company) and tried
and none of these have worked so far. I tried going to the Uniden site listed in the manual and that the requested document not found on the server.
Any suggestions?
Thanks,
Bob