Setting control channel on UBCD396T

Status
Not open for further replies.

panrid67

Member
Premium Subscriber
Joined
Nov 10, 2012
Messages
1
Hi Guys,

Is there a way to specify a control channel to be used when scanning a trunked system? My scanner keeps switching between the control channel I would like it to use (site near to me with very good reception) to another control channel for a site further away which means I get a bad signal. Is there any way to stop this from happening so that my scanner will just use the one control channel always?

Any help I can get would be greatly appreciated.

Thanks.
 

marksmith

Member
Joined
Jun 20, 2007
Messages
4,189
Location
Anne Arundel County, MD
The system will change control channel as it is programmed to do periodically. If you delete it you will get nothing.

On the other hand, if it is a different site, creating separate sites will work.

Sent from my LG-V410 using Tapatalk
 
Status
Not open for further replies.
Top