Single Channel DMR not receiving on BCD536HP

[fdnyfish]

Im using the same FL on my SDS100 and BCD536HP.

I have a FL that is a single Freq DMR set up to my Openspot1 Hotspot.

When I have the hotspot TX, the SDS100 picks up the transmission right away, but the BCD536HP receives nothing.

I have tried this with ID Scanning and ID Searching.

I have both Unit ID's and Talkgroup ID's programmed in this system.

I did try to manually enter a freq on the 536, and set it for Digital Only and that picks up my Openspot1 when it transmits.

What am I doing wrong here?

 

[tvengr]

Dumb question! Do you have the DMR upgrade on the 536? If you do, go to Settings > Upgrade > DMR > E. It will tell you if activated. If not, enter the key.

 

[fdnyfish]

Yes I have the DMR upgrade. I changed a few settings and now i'm receiving it.

 

[fdnyfish]

I have ID Search On, and I am seeing the the TGID on the 536 (I have about 700 TG's in my FL).
Is there a way to also see the UNIT ID on the screen? (I have 15,000 Unit ID's in my FL)

 

[fdnyfish]

I had 3 line display turned on, I shut it off and its all working the way I wanted it. thanks

 

[bubbajoe56]

Yes I have the DMR upgrade. I changed a few settings and now i'm receiving it.

What were the settings you changed to start receiving this?

Thanks

 

[fdnyfish]

I changed modulation to AUTO and Digital Threshold to AUTO