Siren issue after iOS 10.3.1 update

[y84media]

I have an iPhone 6+ running iOS 10.3.1 and an iPad Air running iOS 10.3.
I can listen to my BCD536HP on my iPad with Siren.
When I launch Siren on my iPhone, I get nothing.

On my iPhone I have:
Uninstalled and reinstalled Siren
Hard-rebooted the iPhone
Hard-rebooted my router
Restored my iPhone
Erased my BCD536HP

Still, it works on the iPad and doesn't work on the iPhone. The only thing that I can think of that is different is the version of iOS. Has anyone else had issues with the iPhone after the most recent update?

 

[ScanRite]

Working fine on mine with 10.3.1.

 

[ofd8001]

I'm sure you've confirmed that your iPhone is using your home's router (iPhone settings menu) and you've verified the IP address for the scanner/router connection and enter that in the Siren Connection screen.

Sometimes I have to go through the Set Connection process a couple of times before the connection "takes".

Last just for the heck of it, you might try using the Access Point mode on the scanner rather than Infrastructure. (iPhone has to be close to dongle for this). That would rule out any issues with your wifi/router.

 

[seth21w]

I don't have any experience with apple I've always been an android man but is there anyway you can roll back the updates?

 

[alex5774]

You can only roll back to the previous firmware if apple continues to sign it. 10.3 is no longer signed by apple so it is impossible to revert back from 10.3.1.

 

[n4yek]

.....is there anyway you can roll back the updates?

not on iPhones

 

[Ubbe]

Infrastructure mode still works with 10.3.1 when I just did the update on my iphone 5.

/Ubbe

 

[y84media]

Working fine on mine with 10.3.1.

Ok, thanks for verifying. I'm going to restore my iPhone as a new phone.