• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

Suggestions for waterproof mobile?

Status
Not open for further replies.

cablemonkey

Member
Joined
May 9, 2008
Messages
2
Hi,

I'm looking for a Marine VHF radio that can also have some LMR frequencies programmed into it. Or alternatively a IP67-rated VHF mobile that can survive being installed and operated in a small open rigid hull inflatable boat.

The only one I can find online is a GME unit from Australia. Which is far away and probably wouldn't work out that well for more than a couple of units.

Right now we're sealing Spectras into fibreglass boxes but they're on the way out and we don't have a good replacement identified yet.

Any suggestions?
 

mmckenna

I ♥ Ø
Joined
Jul 27, 2005
Messages
23,838
Location
Roaming the Intermountain West
Even looking at high end P25 mobiles, you will find that they are IP-55 or IP56 ratings, which are good for driven rain, etc. Waterproof is a very nebulous term, as there are different standards. Submersible, water jet, driven rain, "splash resistant" etc are all some of the terms used. IP ratings, Mil-810, etc. are all things you'd need to consider.

If your RHI's have a center console, careful placement will keep any direct splashing off them, but they'll still get damp. A lot of the higher end radios have control heads that get installed on fire truck pump panels, so they'll take some abuse, but not sure how well they'd stand up to salt water.

Since these higher end radios get really expensive, looking for a waterproof enclosure might be a better option. It, at least, would give you more options in radios. One thing to consider would be how often the radios would need their controls changed. If changing channels, etc was a rare event, keeping the radio protected, but having a water resistant speaker and microphone might be a good option. If frequent channel changes, etc are likely, then this will be an issue.

To do it by "the book" you'd need a radio that not only has FCC part 80 certification for the marine VHF channels, but also part 90 for the LMR channels. It isn't difficult to find a radio that will do this, legally.

Another option might be to find a radio that uses a hand held control head. Both Motorola and Kenwood make such radios. While not a permanent solution, it would reduce the amount of hardware that would need to be replaced when it gets damaged.

Some other options:
Get a marine VHF "mobile" type radio, as they would be more suitable, then use a submersible rated VHF hand held for the LMR stuff.
Get basic radios and seal them up the best you can, and just count on frequent replacement.

I've used Motorola CDM radios with a remote head set up on off road vehicles where they were exposed to vibration, dust and occasional rain/splash environments. So far they've all held up well. Most modern LMR radios are actually sealed up pretty well. I wouldn't say "waterproof", but they are pretty good.

Last time I looked, the USCG was using Motorola XTL, or at least that is what I remember. They tend to protect their stuff in the cabin, but likely if they are sticking with them, they are standing up well.

Should be interesting to see what others post, this is an interesting question.
 

gesucks

Member
Joined
Dec 19, 2002
Messages
700
Location
Our Nation's capitol
You can use a Motorcycle radio. The head, speaker and mic will be sealed for the water then put a motorcycle enclosure on the boat for the brick. no the cheapest way but the best way if you do not have a protected area to mount the brick.
 

davidgcet

Member
Premium Subscriber
Joined
Aug 17, 2010
Messages
1,321
APX 7500 mobiles are immersion rated, not sure on the single band versions which are and which are not. not cheap, but they are waterproof if you use all the supplied plugs and factory accy.

What one local EOC did was build a metal box to house their old radios. They just placed the mic and speaker out the box. no need to worry about true immersion, if the radio goes under water it means the boat sank anyway.
 
Status
Not open for further replies.
Top