S
screamin72
Guest
Heya RR folks. I am inquiring about if anyone had any luck using a AM ferrite coil antenna extracted from a parts radio who had success using it on the antenna input of the Nooelec Ham It Up Upconvertor. the device only has a SMA connector. I have a spare 75 ohm BNC connector.that I can use on the SMA to BNC adaptor. How will I terminate the AM ferrite coil antenna to the device?
It was kind of fuzzzy to me where to post this thread because it deals with antenna's below 30mhz, but also, it deals with a SDR "add-on" so to speak.
If anyone has a schematic that will be nice thanks. I can receive AM signals as it is now but not strong enough to my liking. Just 1 AM station is strong the other 6 or 7 in my area are rather weak.
I am aiming toward MW medium wave USA frequency allocation. 535 khz to 1705 khz. Can't expect reception in the long wave band because nothing here is below 535khz
It was kind of fuzzzy to me where to post this thread because it deals with antenna's below 30mhz, but also, it deals with a SDR "add-on" so to speak.
If anyone has a schematic that will be nice thanks. I can receive AM signals as it is now but not strong enough to my liking. Just 1 AM station is strong the other 6 or 7 in my area are rather weak.
I am aiming toward MW medium wave USA frequency allocation. 535 khz to 1705 khz. Can't expect reception in the long wave band because nothing here is below 535khz
Last edited: