• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

Trunking monitor/scan issues

Status
Not open for further replies.

ellwoodops

Newbie
Joined
Jul 2, 2018
Messages
4
hello,
G2 pager with 1.3 firmware
Recently i have been having issues with my pager receiving my trunk tg monitor and scan. Previously everything worked okay, received all three channels i had set and now it cannot get any. it says im out of range, even when im standing next to someone with the same pager, on the same channel. Hopefully this is the right place to look for some help, and if you need any info i can try to provide it, although i am not super programming savvy.
edit: running VHF 136-174MHz antenna
 

blackbelter

Member
Joined
Feb 1, 2004
Messages
795
Apparently lots of people having the same issue after loading the 1.3 FW . Perhaps you can revert back to 1.2,
 

blackbelter

Member
Joined
Feb 1, 2004
Messages
795
Contact your dealer . Did you save your previous CPC and settings, as you would need them as well.
 

ellwoodops

Newbie
Joined
Jul 2, 2018
Messages
4
Contact your dealer . Did you save your previous CPC and settings, as you would need them as well.
I might have a save, but i did not notice much change or having to do extra programming after the upgrade. i will contact my dealer!.
i have a few exports of older programing saves. is there anything specific to look for that makes it known that it is a 1.2 save not a 1.3?
I also have the same version of the pps that was out when 1.3 was out if that makes any difference.
 
Last edited:
Status
Not open for further replies.
Top