sudsyjkh
Member
Hi all.
Have had a 436HP for 2 months now, and have loved playing around with it so far.
Here’s my situation. I’m visually impaired, so using software with a screenreader, and using the radio interface itself by memory (key presses etc.).
So far I’ve been using 1 single FL.
Tomorrow I’ll be traveling for a month or so, without a computer.. .So hoping to use the 6 FLs I’ve created for each location I’ll be visiting; just turning them on/off as needed. I do not have any system or department QKs, I’ve only used the 0-9 startup QKs.
Now after reading the manual, and a couple posts here in the RR forums, thought I could literally just hit the startup QK I’ve picked in the software, (2 for example) followed by enter and that specific Fl and it would be turned on.. .Then that same number, followed by enter again to shut that FL down.
However, when I try hitting the numbers for FLs while scanning, I get some scan list menu, and can’t (quickly) turn these FLs on/off.
Any assistance would be appreciated.
FYI, Youtube links/manuals are *not* helpful; been there, done that, and is unhelpful in my personal situation.
Have had a 436HP for 2 months now, and have loved playing around with it so far.
Here’s my situation. I’m visually impaired, so using software with a screenreader, and using the radio interface itself by memory (key presses etc.).
So far I’ve been using 1 single FL.
Tomorrow I’ll be traveling for a month or so, without a computer.. .So hoping to use the 6 FLs I’ve created for each location I’ll be visiting; just turning them on/off as needed. I do not have any system or department QKs, I’ve only used the 0-9 startup QKs.
Now after reading the manual, and a couple posts here in the RR forums, thought I could literally just hit the startup QK I’ve picked in the software, (2 for example) followed by enter and that specific Fl and it would be turned on.. .Then that same number, followed by enter again to shut that FL down.
However, when I try hitting the numbers for FLs while scanning, I get some scan list menu, and can’t (quickly) turn these FLs on/off.
Any assistance would be appreciated.
FYI, Youtube links/manuals are *not* helpful; been there, done that, and is unhelpful in my personal situation.