I am about to pull my hair out over this. I have looked everywhere for an answer but can't seem to find anything to help. I was attempting to update the firmware on my UV380 from D017.005 to V017.005 to be able to accept the DMR ID contact list. First off I attempted to download the Flash tool off of the tyt888.com website but when i click on the download it flashes and disappears. I am unable to find anywhere on my computer where it downloaded if it did. So I downloaded the Tytera Flash Tool by KG5RKI. I then downloaded
MD-UV380(CSV)-V17.05.bin firmware from the tyt website and followed the instructions for flashing the firmware to the radio. After it was finished I turned off the radio and turned it back on only to find it was still in the program mode. I have attempted to re-flash it several times with no luck. I have even attempted to re-write the radio with a code plug from before the flash. When I read the radio is shows firmware T012.010. All the stuff I find online is geared towards the MD-380 and not a whole lot for the UV380. Any help would be greatly appropriated. Oh and I am CPS version 1.07 on windows 10. I also tried on windows 7.
MD-UV380(CSV)-V17.05.bin firmware from the tyt website and followed the instructions for flashing the firmware to the radio. After it was finished I turned off the radio and turned it back on only to find it was still in the program mode. I have attempted to re-flash it several times with no luck. I have even attempted to re-write the radio with a code plug from before the flash. When I read the radio is shows firmware T012.010. All the stuff I find online is geared towards the MD-380 and not a whole lot for the UV380. Any help would be greatly appropriated. Oh and I am CPS version 1.07 on windows 10. I also tried on windows 7.