G7HID
Member
Why don't you contact Uniden Europe with your concerns.
See post #18....
Mike
Why don't you contact Uniden Europe with your concerns.
I was advised this morning that a f/w update is in process/testing for the Europe version. I do not have an estimated release timeframe, but since it is based on the US version which has been released, it will likely be soon.
I was advised this morning that a f/w update is in process/testing for the Europe version. I do not have an estimated release timeframe, but since it is based on the US version which has been released, it will likely be soon.
As to just receiving/decoding simplex: I get 80-90% decode on simplex with the above settings (FM, MAN 8). Due to the 30 mS duty cycle, 100% isn't possible.
Ummm.....maybe there are a lot of us on this forum then that have simply bought duff products, as we can't get anywhere near those stunning results: this is even with the latest firmware/manual threshold & FM settings/battery door shielding/additional capacitor fixes applied to any of my 436HP's. I'd estimate about 80% of DMR simplex signals are detected, and about 20% of them decode with intelligible voice. In comparison, in the same test environments, I'd say my TRX-1 successfully decodes about 95% of DMR simplex comms. Even a tapped scanner hooked up to DSD+ will successfully decode at least 90% of the same signals.
I just found out about the BCD325P2 and the fact that it had a DMR upgrade available. That's a cheaper option, and smaller, but probably not as good for DMR.
Thanks for that... Any ideas on the contact details for Uniden Europe please ??
Mike
Found this, not sure if the e-mail is still valid:
UNIDEN EUROPE liaison office of Uniden Corporation Japan
Ettenhoven 108 tel + 32 3 568 07 90
B 2940 Hoevenen ( Belgium ) fax + 32 3 568 01 18
e-mail : lyssens@uniden.be
The 325 lacks the recording capability, and IMHO it is not convenient if compared with the 436/3600 features.
Anyway, before it's too late, consider also the Whistler TRX-1.
It is reputed to perform better than the Unidens in DMR decoding and capturing a nearby DMR simplex signal
(the Spectrum Sweeper and the Close Call RF Capture technologies are based upon different algorithms).
I was advised this morning that a f/w update is in process/testing for the Europe version. I do not have an estimated release timeframe, but since it is based on the US version which has been released, it will likely be soon.