Greetings, I am attempting to build a programming unit for the Unication G1. In the past, I have been able to program Motorola Minitor 3/4/5 pagers with the same method. On the Minitor, you just needed Ground, TX and RX. You were then able to read and write no problem with PPS. (GND to GND, TX to RX and RX to TX)
Attached below is the pinout for the G1, It is extremely similar to the Minitors except for the "Charge/Program Detect" pin. Do we need to apply power to that in order to read/write or should we be able to read/write with just the neutral/tx/rx like on the Minitors?
Many Thanks!
Attached below is the pinout for the G1, It is extremely similar to the Minitors except for the "Charge/Program Detect" pin. Do we need to apply power to that in order to read/write or should we be able to read/write with just the neutral/tx/rx like on the Minitors?
Many Thanks!
Free-Shipping-10pcs-lot-PL2303-TA-USB-TTL-RS232-Convert-Serial-Cable-PL2303-TA-Compatible
Image Free-Shipping-10pcs-lot-PL2303-TA-USB-TTL-RS232-Convert-Serial-Cable-PL2303-TA-Compatible hosted in ImgBB
ibb.co