Unication G5 Analog 2 tone timers

[spitzman]

Our dept recently purchased two Unication G5 pagers. I've programmed our dept freq and tone freq. When the 2 tone is played over the air, the pager activates and alerts. The issue I'm having, is our second tone freq is short, so by the time the pager "recognizes" the second tone and plays the alert tone, the second tone is over and we only get a few alert beeps out of the pager.

Does anyone know of a way to change a time parameter somewhere so the pager begins alerting immediately after the second tone freq is heard?

 

[w2lie]

On Tab 8, change the alert from "By Tone" to "Fixed Duration"

 

[spitzman]

Hey! That did exactly what I wanted it to, however this introduced maybe a bug? Now after the tone is received, this screen gets stuck. I configured it to be red. Previously when the tone was gone, it would show the recording delay timer. I can switch to another knob position and this clears the screen.

 

[w2lie]

Are you using firmware v1.30?

 

[spitzman]

Are you using firmware v1.30?

Yes I am. I think I found the problem. I was looking in tab #3 and changed the 2-Tone paging durations to match our tone. It works great now. Previously it was on the Motorola Tone table.

 

[Devito96]

Do you guys know how to fix this. I want it record the whole thing. If you look at the pics one record and the second part doesn't

 

[Webodisk]

can you post a snip of your setting for the knob position ? looks like a timing issue

 

[Devito96]

can you post a snip of your setting for the knob position ? looks like a timing issue

I’m new to this pager. Where do I go for that?

 

[Webodisk]

screen shot your D6 knob position settings

 

[Devito96]

Ok.

 

[Webodisk]

this screen

 

[Devito96]

This screen

 

[Webodisk]

Try these settings I have I have in my photo and see if that helps

 

[Devito96]

That should fix this?