Unication G5

Murr7555

Newbie
Joined
May 31, 2020
Messages
2
Anybody in the Delaware County area that could reprogram my G5? Will pay for your time.
 

cavmedic

Member
Premium Subscriber
Joined
Sep 2, 2012
Messages
678
Location
Pottstown Pa
I work down there, if you are on the same firmware and software, shoot me your code plug and I can help ya out

If not, I can meet up, read it, work on it and then reprogram later in the week.
 

Murr7555

Newbie
Joined
May 31, 2020
Messages
2
I work down there, if you are on the same firmware and software, shoot me your code plug and I can help ya out

If not, I can meet up, read it, work on it and then reprogram later in the week.
Ok. I work on getting the code plug tomorrow after work. It's programmed but the squelch stays open on Sector 2 whenever there is a transmission. All other sectors and counties work fine. Also trying and failing to set up the two tone alert for Newtown Square and Broomall fire departments,
 

cavmedic

Member
Premium Subscriber
Joined
Sep 2, 2012
Messages
678
Location
Pottstown Pa
Well the UHF paging is not simulcast and that’s out of Lima, so that might some of the issue unless it’s only a programming type thing with alerting.

Another to check is your bandwidth settings. Most of everything is still wide band with the exception of a few frequencies.
 
Top