Uniden BCD396T Tippecanoe and Indiana P25 systems not picking up

[x7yth4x9u]

I have purchased a Uniden BCD396T. I use ARC396 software to program my scanner. I performed a factory reset and confirmed that the Firmware was the most current firmware for this scanner. I successfully loaded the Tippecanoe County (P25) Project 25 Phase I and Indiana Project Hoosier SAFE-T Project 25 Phase I frequencies correctly . I connected ARC396 to RadioReference and loaded the Agencies (frequencies) and Talk Groups with no problem. The scanner scans and will once in a while pick up traffic from Benton County or another agency BUT is only does this occasionally. I have turned the squelch to zero and doubled checked that frequencies and talk groups were installed on the scanner.

Any suggestions on other settings I can check for P25 phase I scanning?

 

[tvengr]

The 396T can trunk only one site per system. On the Indiana Hoosier system, I assume that the West Lafayette site is closest to you. If that is true, you should have 858.7125 and 859.7125 as the only frequencies entered into the site.

 

[x7yth4x9u]

I have made the changes.

 

[tvengr]

x7yth4x9u Please check your inbox if you have not already done so.