I have a Uniden BCT15X scanner and the ARC15 software. The software detects the scanner just fine. When I go to WRITE to the scanner it times out and gives me an error. If I use virtual control it "talks" just fine to each other. It also will not allow me to read the scanner into the software. Same error. Check connections etc. What am I missing here? I have been programming scanners and radios for years but this one has be stumped. Using the front interface on the scanner, the correct cable, a Gigaware USB to Serial adapter. Firmware ver 1.05.03 in the scanner. (Is there a newer firmware?) I couldn't find it if there is one. Using Windows 10.
Thanks in advance,
Dave
Thanks in advance,
Dave