Uniden Serial Port Issue

Status
Not open for further replies.
Joined
Mar 4, 2007
Messages
164
Location
Arizona- near New Mexico
internal battery

JUST plugged in or plugged in and turned on? You need it turned on to charge the clock battery.
When I plug mine bcd436hp in to charge the internal battery, it says either mass storage or serial port- I chose serial port but get a notice there is no serial port driver for the BCD436HP then the message battery failure.
 

UPMan

In Memoriam
Premium Subscriber
Joined
Apr 19, 2004
Messages
13,296
Location
Arlington, TX
On the page of the forum you want to post in, near the top left of the page is a link "New Thread."
 

Voyager

Member
Joined
Nov 12, 2002
Messages
12,059
When I plug mine bcd436hp in to charge the internal battery, it says either mass storage or serial port- I chose serial port but get a notice there is no serial port driver for the BCD436HP then the message battery failure.

You get the no serial port driver on the scanner? You should not. But, that is the correct selection to charge the clock battery (or run the scanner in general).
 
Joined
Mar 4, 2007
Messages
164
Location
Arizona- near New Mexico
You get the no serial port driver on the scanner? You should not. But, that is the correct selection to charge the clock battery (or run the scanner in general).

I was getting the no serial driver error message under device manager till I bought winzip to unzip the usb to serial port driver that Paul provided. Now I have the driver. The computer and scanner connected by the USB cable (to the serial port) now have both been running for over 25 hours.
 
Status
Not open for further replies.
Top