Unitrunker and PSR800 for Getting Motorola/P25 Parameters

Status
Not open for further replies.

cocomonk22

Member
Joined
Mar 5, 2014
Messages
28
Need assistance getting the trunking system information. I know the control channel UHF frequencies, and based on the sound, it could either be Motorola or Phase 25. I don't know any of the trunking parameters besides that. So far I have been unable to get any control channel information dumped.

Here is my configuration:

PC/IF Out is set (previously had it set to output to SD files, but it didn't generate any CC info):
14043470182_c4b345948a_o.png


Site Frequencies (based on frequencies that had control channel noise when I was using Spectrum Sweeper):
14066687473_b2149aa168_o.png


Site Options:
14043469892_5e5aac55bc_o.png


Trunking tables (not sure if these parameters are correct):
14023532636_c46bae2726_o.png


Talkgroup Details:
14047121464_5df14dd416_o.png


Added the trunked system to scanlist 2:
14066687553_01e79dc57b_o.png


Unitrunker Options set to decimal:
14047121354_f8d3a7ef5f_o.png


Com4 settings from Device Manager:
14066687643_a68e04a76b_o.png


Receiver settings in Unitrunker:
14046670385_a9b5a2f0b6_o.png


Started up PSR800 to scan only scanlist 002 and am getting nothing.
 
Last edited:

cocomonk22

Member
Joined
Mar 5, 2014
Messages
28
I'm thinking it might be easier to set PC/IF through the headphone jack like a dicriminator, and then just scan the control channel frequencies like conventional channels.
 

SCPD

QRT
Joined
Feb 24, 2001
Messages
0
Location
Virginia
Might not matter but the frequency for channel 10 doesn't look right. As a matter of fact, most of those frequencies are not licensed for trunked operation in the state of Hawaii. Which island is this?

http://www.radioreference.com/apps/db/?fccCallsign=WPSQ394

http://www.radioreference.com/apps/db/?fccCallsign=WNMM962

Also, it might not be Motorola or P25 but DMR eg. "MotoTRBO" or NXDN.

Looks like you'll need to map this system out before you can program it - so, yes - use discriminator audio instead.

Add a new signal receiver configured for discriminator audio. Enable discriminator output on your PSR800, adjust the volume level while observing the Scope tab, and go from there ...
 
Last edited:
Status
Not open for further replies.
Top