ericcumbee
Newbie
- Joined
- May 31, 2017
- Messages
- 11
Hey everyone,
I just got two RTL Dongles, and have them setup with Unitrunker to monitor our local radio network that is a Motorola SmartNet II system with Analog voice channels.
I have a setup where the 1st dongle monitors the control channel, and the 2nd follows the voice channels.
Everything was working last night, until this morning when apparently they jumped to a different control frequency. Once I found the new control frequency and reconfigured the VCO on the 1st Dongle everything started to work again.
How do I configure Uni-trunker to follow when the control channel changes? is it just a matter of Adding Additional VCOs for each possible Control Channel?
I just got two RTL Dongles, and have them setup with Unitrunker to monitor our local radio network that is a Motorola SmartNet II system with Analog voice channels.
I have a setup where the 1st dongle monitors the control channel, and the 2nd follows the voice channels.
Everything was working last night, until this morning when apparently they jumped to a different control frequency. Once I found the new control frequency and reconfigured the VCO on the 1st Dongle everything started to work again.
How do I configure Uni-trunker to follow when the control channel changes? is it just a matter of Adding Additional VCOs for each possible Control Channel?