Still not 100% when it comes to using Unitrunker and
SDR# (Sharp).
Using Unitrunker as Standalone.
Right now I have 2 SDR Dongles that I'm using for NJSP.
SDR #1 is setup as the Signal Decoder.
I have 4 VCO's but I am only using 1 so far. It is
parked on 860.9375 (The control channel)
SDR#2 is setup as voice.
There are 3 VCO's setup (by default).
Should I be using all 3 VCO's or just 1?
I'm getting activity on all 3 but sometimes they
are active at the same time and you can't understand
what's going on because of the amount of chatter
from 3 VCO's.
Question #2. What benefit do I get when using Unitrunker
with SDR Sharp? It's very confusing to me to use 2 different
programs, needing 2 or 3 plugins, along with DSD+ and Com0Com.
Especially when I can follow trunking with using Unitrunker alone
Am I missing something?
SDR# (Sharp).
Using Unitrunker as Standalone.
Right now I have 2 SDR Dongles that I'm using for NJSP.
SDR #1 is setup as the Signal Decoder.
I have 4 VCO's but I am only using 1 so far. It is
parked on 860.9375 (The control channel)
SDR#2 is setup as voice.
There are 3 VCO's setup (by default).
Should I be using all 3 VCO's or just 1?
I'm getting activity on all 3 but sometimes they
are active at the same time and you can't understand
what's going on because of the amount of chatter
from 3 VCO's.
Question #2. What benefit do I get when using Unitrunker
with SDR Sharp? It's very confusing to me to use 2 different
programs, needing 2 or 3 plugins, along with DSD+ and Com0Com.
Especially when I can follow trunking with using Unitrunker alone
Am I missing something?