I am using a multi-RTL setup to monitor an EDACS system, and I've found that when the control channel changes on this EDACS system, Unitrunker fails to "hunt down" the new control channel being used when told to do so.. It instead hangs on the existing control channel and reports "degraded"a signal strength with yellow bars (via the colored signal strength indicator). There are times when I see she *HAS* tried to hunt, but just didn't land her prey (all the sudden parked on a another confirmed control channel but not the active one.)
I've enabled the "chase" boolean and adjusted the dwell value to to no avail. All known control channels are marked as "control" and "confirmed"
What am I missing?
I've enabled the "chase" boolean and adjusted the dwell value to to no avail. All known control channels are marked as "control" and "confirmed"
What am I missing?