DarrelH
Member
I have a setup to listen to a Motorola Smartnet II analog system, working well, with
- Windows 7
- 1 SDR dongle for control channel, with SDR# (SDRsharp.. however you decide to say it these days)
- 1 SDR dongle for voice channel, with another instance of SDR#
- Unitrunker successfully decoding the cc and steering the 2nd instance of SDR# for the voice channels.
The problem I hit is when the control channel changes, the 1st instance of SDR# is just sitting there on the old control channel, so everything is no bueno until I notice the issue and manually locate another control channel.
I searched through some posts back to 2010 and didn't see an answer for this situation. Is there a way to have Unitrunker also steer the 1st instance of SDR# that's on the control channel, to adjust it on the fly to alternates or based on data fed on the original control channel before it goes dead?
Thanks
DH
- Windows 7
- 1 SDR dongle for control channel, with SDR# (SDRsharp.. however you decide to say it these days)
- 1 SDR dongle for voice channel, with another instance of SDR#
- Unitrunker successfully decoding the cc and steering the 2nd instance of SDR# for the voice channels.
The problem I hit is when the control channel changes, the 1st instance of SDR# is just sitting there on the old control channel, so everything is no bueno until I notice the issue and manually locate another control channel.
I searched through some posts back to 2010 and didn't see an answer for this situation. Is there a way to have Unitrunker also steer the 1st instance of SDR# that's on the control channel, to adjust it on the fly to alternates or based on data fed on the original control channel before it goes dead?
Thanks
DH