wiredwrx
Member
- Joined
- Dec 20, 2004
- Messages
- 45
I am using unitrunker 1.0.26.16, though I may update when I get a chance.
I am attempting to monitor the this system Interagency Communications Interoperability System (ICIS) Trunking System, Various, California - Scanner Frequencies
I am close to site 7 (Culver City) but it appears that I should be able to monitor site 2 (Oat Mountain) easily due to the coverage map.
I have set my SDR on the site 7 primary control channel (482.3625) but it appears unitrunker doesn't see it as a control channel. I then set it to the secondary control channel (482.5625) and it immediately popped up on unitrunker. Most of the information has populated, and appears correct. However, after sitting on the control channel for about 8 hours, it still has not been able to ascertain what the systems frequencies are. Screen shot attached.
I then setup my SDR to try and monitor Oat Mountain control channel, but I was not able to find the control channel. Instead, I was able to find Site 1. When I did, again, a window popped up immedaitely, and sat for several hours logging activity, but the frequencies never populated. I searched the internet, and found a how to that said to click the calculator, and then standard. So I did, and now the unitrunker screen has a bunch of 800 mhz frequencies, which is definitely not correct. Is there a way to remove the system from Unitrunker, and start again, or should/can I manually change the frequencies. Screen shot attached.
I would like to start trying to follow talkgroups, and think I need the proper frequencies to try that. I know the list of frequencies, can/should I just fill them in manually? Is there another solution.
Also, how can I set talkgroup priorities. I saw that mentioned on the board.
Thanks
I am attempting to monitor the this system Interagency Communications Interoperability System (ICIS) Trunking System, Various, California - Scanner Frequencies
I am close to site 7 (Culver City) but it appears that I should be able to monitor site 2 (Oat Mountain) easily due to the coverage map.
I have set my SDR on the site 7 primary control channel (482.3625) but it appears unitrunker doesn't see it as a control channel. I then set it to the secondary control channel (482.5625) and it immediately popped up on unitrunker. Most of the information has populated, and appears correct. However, after sitting on the control channel for about 8 hours, it still has not been able to ascertain what the systems frequencies are. Screen shot attached.
I then setup my SDR to try and monitor Oat Mountain control channel, but I was not able to find the control channel. Instead, I was able to find Site 1. When I did, again, a window popped up immedaitely, and sat for several hours logging activity, but the frequencies never populated. I searched the internet, and found a how to that said to click the calculator, and then standard. So I did, and now the unitrunker screen has a bunch of 800 mhz frequencies, which is definitely not correct. Is there a way to remove the system from Unitrunker, and start again, or should/can I manually change the frequencies. Screen shot attached.
I would like to start trying to follow talkgroups, and think I need the proper frequencies to try that. I know the list of frequencies, can/should I just fill them in manually? Is there another solution.
Also, how can I set talkgroup priorities. I saw that mentioned on the board.
Thanks