blueline_308
Member
Need help with C Ch. issues. Help UPman
Upman, I hope that you or some of your buddies at Uniden can help me address this problem.
In my area, there are several Mot 800 TRS that share some of the same freqs. If I have system A programmed for CC only, and system B programmed for CC only, when sys A locks onto one of its voice channels that just happens to be the CC for sys B, it stays locked on to that freq, even if the CC data is much weaker, close to equal, or stronger than the voice signal. It will display the sys info for sys A and a TGID that doesnt match either sys. Is there anything like data skip for TRS? Shouldn't it recognize the RX signal as CC data and mute and resume scanning?
Im using a 996.
Please help me with this.
Thanks,
Jim
Upman, I hope that you or some of your buddies at Uniden can help me address this problem.
In my area, there are several Mot 800 TRS that share some of the same freqs. If I have system A programmed for CC only, and system B programmed for CC only, when sys A locks onto one of its voice channels that just happens to be the CC for sys B, it stays locked on to that freq, even if the CC data is much weaker, close to equal, or stronger than the voice signal. It will display the sys info for sys A and a TGID that doesnt match either sys. Is there anything like data skip for TRS? Shouldn't it recognize the RX signal as CC data and mute and resume scanning?
Im using a 996.
Please help me with this.
Thanks,
Jim
Last edited: