KC8FAS
Member
Im using a USB programing cable to program my pro 96 every time i plug it in it gos to clone mode and win96 says its sending but nothing loads. Does anyone have a clue whats going on.
USB Programing cable problem
- Thread starter KC8FAS
- Start date
- Status
DonS
Member
Did you configure Win96 to use the correct COM port via the Configuration -> Serial Port menu?
You can find the correct COM port by looking in Device Manager, under "Ports (COM & LPT)". In the above configuration item, Win96 will only show ports that "exist" on your machine and will flag any that are already opened by other software.
You can find the correct COM port by looking in Device Manager, under "Ports (COM & LPT)". In the above configuration item, Win96 will only show ports that "exist" on your machine and will flag any that are already opened by other software.
Make sure you are using the stereo connector and not the short pig tail mono converter
- Status
