Vertex VX-3200V problem

[wcu02mpa]

I have a VX-3200V and everything works great (even into the HAM portion) except one thing; no transmit audio. I have great receive, full power transmit, but no audio. Does anyone know where I might find a service manual and/or a possible reason as to why I have no audio (known problem). The mic is good as I tested it on another radio....FTL-7011. I am assuming they use the same 8-pin mic.

 

[cabletech]

Do you have a general coverage reciever or normal scanner or a service montior that you can input one of the frequency's from the Vertex into to listen too? If you do, then do so and transmite from the vertex and see if you trully are NOT transmiting audio.

If the radio Is tranmitting audio, then the channel information in the Vertex maybe wrong.

 

[Rozie45]

If you have the programing software, there's a setting that switches the mic audio vs. the db-9 connector in the rear. That connector is sometimes used for other options (repeater; remote mics, etc). That should fix it. If you can't find it, message me, and I'll check my software. I just can't remember where it is in the software off the top of my head....

I have a bunch of these and got caught with this one before.

Good luck

 

[wcu02mpa]

need further

I do have a service monitor and yes the TX power is there, but no mic audio. Rozie45 I looked through the menus in the software but could not find an audio route setting. I found plenty of other stuff I was looking for. It seems the function ribbon would hold the answer, but nothing found. If you happen to come up with anything let me know.

Thanks

 

[m-gerty]

Check : Functions - > Key Assingment, check box on bottom right (back of radio) should be "NONE"

 

[wcu02mpa]

Didn't fix it

Well the none was already selected for that menu. I actually like that software as it is pretty intuitive. Any other areas for me to look??