Hi All,
So I consider myself fairly radio and computer savvy so I was not worried when I purchased my new VX-351 w/ software and cable.
I installed the software onto a brand new computer using Windows 7. Did a Save As so I had a default settings as a back up, and started entering my RX and TX freqs. Succesfully entered them all, plugged in USB cable, Windows automatically found and I installed plug ins. It assigned them to the appropriate COM port HOWEVER, Vertex software greys out the COM port in the Configuration tab, it only allows me to select the baud rate???
Any ideas on what I may be doing wrong??
So I consider myself fairly radio and computer savvy so I was not worried when I purchased my new VX-351 w/ software and cable.
I installed the software onto a brand new computer using Windows 7. Did a Save As so I had a default settings as a back up, and started entering my RX and TX freqs. Succesfully entered them all, plugged in USB cable, Windows automatically found and I installed plug ins. It assigned them to the appropriate COM port HOWEVER, Vertex software greys out the COM port in the Configuration tab, it only allows me to select the baud rate???
Any ideas on what I may be doing wrong??