SDS100/SDS200: Will no longer hold on System or Dept

[kkn50]

After updating firmware to Main 1.23.07 and Sub 1.03.05 my SDS200 will no longer hold on a System or Dept. Pressing the System or Dept key causes it to hold for about five seconds then resume scanning. Pressing the Channel key causes it to hold on the channel until the key is pressed again so no problem with it. Any ideas how to resolve this?

 

[donc13]

After updating firmware to Main 1.23.07 and Sub 1.03.05 my SDS200 will no longer hold on a System or Dept. Pressing the System or Dept key causes it to hold for about five seconds then resume scanning. Pressing the Channel key causes it to hold on the channel until the key is pressed again so no problem with it. Any ideas how to resolve this?

1.23.07 for main? Mine is up to date and shows 1.23.03

 

[jtwalker]

Mine works fine holding on a system or department on 1.23.07 / 1.03.05.

Perhaps you are hitting scroll knob before the hold has a chance to take?

 

[jtwalker]

1.23.07 for main? Mine is up to date and shows 1.23.03

Your FW is not up to date as of yesterday.

 

[donc13]

My BAD. I see 1.23.07 main is latest, a few days ago. Let me get it and check against your original msg

 

[donc13]

Your FW is not up to date as of yesterday.

Yea, I just saw that.

 

[donc13]

OK, now updated to 1.23.07

I am able to hold on System, Dept or Channel on my SDS200 so I can not duplicate your issue.

 

[kkn50]

Update: After trying the Hold on several different systems, noted that this was an issue on only one system. Hold worked normally on the other systems. I deleted the system in question in the scanner and profile, reprogrammed the profile, uploaded the new profile and now Hold is working properly on all systems. Resolved.