D
DaveNF2G
Guest
Win500 is not accepting the offset and step values that I am receiving from local VHF P25 sites. It resets them to zero when I move to the next field in the Trunking Tables window.
One example:
-Tables
#Format: Table ID,Base Freq,Spacing,Input Offset,Assumed/Confirmed,BandWidth
00,851.00625,0.00625,-45.00000,"Confirmed",0.00625
01,762.00625,0.00625,30.00000,"Confirmed",0.00625
02,136.00000,0.01000,5.97500,"Confirmed",0.01250
03,142.42250,0.00500,13.15000,"Confirmed",0.01250
04,143.43000,0.00500,15.66250,"Confirmed",0.01250
05,147.01250,0.00250,32.30000,"Confirmed",0.01250
06,136.00000,0.01000,8.18750,"Confirmed",0.01250
07,136.00000,0.01250,6.00000,"Confirmed",0.01250
I am entering the tables on the same numbered lines as are indicated in the above list (Table ID). Win500 will accept the base frequencies, too. But when I enter the Step (Spacing or BandWidth - not sure which one it's supposed to be as PRO96COM doesn't use same terminology:roll: ) or Offset, Win500 defaults them back to zero before saving.
This happens whether I use P25 AUTO or P25 MANUAL as the TSYS mode.
One example:
-Tables
#Format: Table ID,Base Freq,Spacing,Input Offset,Assumed/Confirmed,BandWidth
00,851.00625,0.00625,-45.00000,"Confirmed",0.00625
01,762.00625,0.00625,30.00000,"Confirmed",0.00625
02,136.00000,0.01000,5.97500,"Confirmed",0.01250
03,142.42250,0.00500,13.15000,"Confirmed",0.01250
04,143.43000,0.00500,15.66250,"Confirmed",0.01250
05,147.01250,0.00250,32.30000,"Confirmed",0.01250
06,136.00000,0.01000,8.18750,"Confirmed",0.01250
07,136.00000,0.01250,6.00000,"Confirmed",0.01250
I am entering the tables on the same numbered lines as are indicated in the above list (Table ID). Win500 will accept the base frequencies, too. But when I enter the Step (Spacing or BandWidth - not sure which one it's supposed to be as PRO96COM doesn't use same terminology:roll: ) or Offset, Win500 defaults them back to zero before saving.
This happens whether I use P25 AUTO or P25 MANUAL as the TSYS mode.