WIN96 and P25 Configuration

Status
Not open for further replies.

daedalus

Member
Joined
Dec 31, 2002
Messages
178
Location
Bolivia.NC
This is almost certainly going to fall into the 'dumb question' category, but I'm confused.

In WIN96 (PRO2096) I can't figure out what settings to use for the following:

Cranford, Township of
Frequency Input License Type Tone Alpha Tag Description Mode Tag
471.60000 474.60000 WPWJ842 RM 293 NAC 1 Police P25
477.50000 480.50000 WPWJ842 RM 293 NAC 2 Police P25

I have the frequencies set OK. I have the mode set to FM and have no clue how to enter a NAC code.

I receive the transmissions, but they sound somewhat garbled unless I am very close to the transmitter; not encrypted, just like they are under water.

Can someone advise how I should enter the information?

Thanks
 

KE5BCP

Analog Freq
Premium Subscriber
Joined
Dec 19, 2002
Messages
1,341
Location
Lewisville, Texas
This is almost certainly going to fall into the 'dumb question' category, but I'm confused.

In WIN96 (PRO2096) I can't figure out what settings to use for the following:

Cranford, Township of
Frequency Input License Type Tone Alpha Tag Description Mode Tag
471.60000 474.60000 WPWJ842 RM 293 NAC 1 Police P25
477.50000 480.50000 WPWJ842 RM 293 NAC 2 Police P25

I have the frequencies set OK. I have the mode set to FM and have no clue how to enter a NAC code.

I receive the transmissions, but they sound somewhat garbled unless I am very close to the transmitter; not encrypted, just like they are under water.

Can someone advise how I should enter the information?

Thanks
The 96 and 2096 don't accept NAC code programming.

Just enter the frequency and leave it as FM.
 
Status
Not open for further replies.
Top