Win96 multi custom freq tables?

Status
Not open for further replies.

cassidy1190

Member
Joined
Sep 26, 2004
Messages
267
Location
Belmar, NJ
I have a bit of a dilemma programming my 2096. Using win96 I want to enter the multi custom frequency table required for the system I am monitoring. I am a bit confused with some of the extra information the window asks for. I understand base, spacing, and offset, but what is channel low and channel high? How do I figure out what to enter? Also, if the system only has two frequency ranges, what do I enter for the rest of the tables? (Assuming 0s all across)

Thanks for your help,
Dan
 

ka3jjz

Wiki Admin Emeritus
Joined
Jul 22, 2002
Messages
23,246
Location
Bowie, Md.
Assuming you are programming a NJ or Pa. system, you should ask in the appropriate forum (we have one for each state). No doubt someone there can give you the proper lo/hi channel and whatever else you need. 73 Mike
 

fmon

Silent Key Jan. 14, 2012
Joined
May 11, 2002
Messages
7,741
Location
Eclipse, Virginia
i have a bit of a dilemma programming my 2096. Using win96 i want to enter the multi custom frequency table required for the system i am monitoring. I am a bit confused with some of the extra information the window asks for. I understand base, spacing, and offset, but what is channel low and channel high? How do i figure out what to enter? Also, if the system only has two frequency ranges, what do i enter for the rest of the tables? (assuming 0s all across)

thanks for your help,
dan
P25 VHF System.
Code:
 8192 12287 136.00000  8192 2.500
12288 16383 146.00000 12288 2.500
16384 20479 156.00000 16384 2.500
Chech this Wiki page Win96 - The RadioReference Wiki
 
Status
Not open for further replies.
Top