wintelive and GNU radio python error?

[welshevo]

hey all followed the install from curlyboy readme file.. and all appears good , however when i try and run the telive GRC 10 ch project it starts to run then python crashes so cant go no further? any suggestions folks???

 

[tango20k]

dear friend ,
What OS you are running ,u also did you try to disable some channels that you would not need in grc file .

i disable 6 of them immediately , this reduces the processor burden and to some level improves decoding.


you may also try to use single channel grc and advise.

best of luck

 

[welshevo]

Wintelive

morning ... im using windows 7 64bit i havent tried disabling channels yet? but dont think it would make much difference? as ive tried various channel counts in GNU. 10, 4, 1 chs.. the FFT window doesnt even load and python crashes?