rapidcharger
Member
Does anyone know how to delay the start of a BOT PTT ID on a x180 series kenwood?
On Icom software, they call it "PTT ID Delay" where you can adjust the time from key down to the sending of the MSK in fractions of a second". But Kenwood calls a different behavior PTT ID delay which I don't fully understand the prupose of but needless to say it's not the same thing as it measures the delay in full seconds..
PTT ID is getting cut off by the repeater so I need to set it back a little, maybe 100ms.
I can't find anything in that will let me do that short of putting the ID at the EOT.
On Icom software, they call it "PTT ID Delay" where you can adjust the time from key down to the sending of the MSK in fractions of a second". But Kenwood calls a different behavior PTT ID delay which I don't fully understand the prupose of but needless to say it's not the same thing as it measures the delay in full seconds..
PTT ID is getting cut off by the repeater so I need to set it back a little, maybe 100ms.
I can't find anything in that will let me do that short of putting the ID at the EOT.