• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

XPR 5350e issues

kurtbelyeu

kurtbelyeu

Member
Joined
Mar 30, 2022
Messages
9
Hi, I have a couple XPR 5350e’s installed and one of them just started to beep when you transmit on channel 3 but receives just fine. All the other channels work for both transmit and receive, only this one channel has an issue. I went ahead and swapped this radio with another 5350e for a different location, and all was fine for a couple days now I am getting this same issue… beeping while trying to transmit on channel 3 but not actually transmitting.

We do have a repeater, but I would expect the transmit issue would be across the board and not just one radio.

Any suggestions on where to start? FYI no changes have been made to the system over the last 3+ years.
 
You must log in or register to reply here.

Similar threads

A
XPR / SL Non-E Firmware not on Customerhub?
Replies
3
Views
212
hockeyref2
H
Enickel02
XPR XPR 3500 Unable to clone
Replies
14
Views
403
K9KLC
K
S
wideband 25 kHz trick and DMR Repeater issue
Replies
6
Views
783
scanomanicodz
S
T
XTL/XTS5000 Simplex Emergency Programming
Replies
1
Views
551
thisguyneedsabeer
T
K
MT500 no transmit audio
Replies
11
Views
656
knockoffham
K
Top