Xtl-5000 csq to hear rx traffic issue

[vittles04]

Hello,
First off here is the radio information you'll need.

MODEL: M20KSS9PW1AN
CPS VERSION: R17.01.00

While NOT in scan mode I have to have the "silent monitor" button on to hear radio traffic. When in scan mode I can hear traffic but usually keep the silent monitor button on but have confirmed NO AUDIO with the silent monitor off. I seem to transmit fine as I haven't heard any complaints yet and his been awhile till I was able to take my issue to the forum. Can somebody assist in what I am over looking ????????

Thanks in advance !!!

:roll:

 

[msingewald]

It sounds like your channel is programmed with a pl or dpl decode that doesn't match what you are trying to monitor.

Can't think of anything else.


Sent from my iPad using Tapatalk

 

[davidzimmerman]

i would say the same thing check RX and TX DPL or PL tones its possible its a SPLIT tones used we have a repeater with different rx\tx DPL

 

[vittles04]

I just re-checked all channels including the zones that are RX only which this same issue is also present. DPL/PL are ALL correct.

 

[cackis]

Is it only on one channel or all of the channels you are trying to listen to? I had a similar issue with my XTL5000 UHF on one channel and it wasn't the XTL that was the problem. Had our tech service the base radio I was having problems receiving and it had drifted slightly off frequency so I was only able to receive it in monitor on the XTL. Once serviced, no problems at all.

 

[evfd1625]

It doesn't have a selective calling option enabled does it? I.E. Quick call or MDC call etc...