xtl2500 pl

[E5911]

XTL2500 VHF
I do not use the HUB
I want the PL active on Rx all the time unless I press the monitor button.
Even during scan. I have RF noise on the channel.
How do I set up on CPS?
(HUB defeats scan unchecked)
(Carrier Detect checked in Conventional)
(PLs are programmed in Zone channel assignment)
What else am i missing ?
Still getting noise Even with Sq turned all the way up

 

[nokones]

XTL2500 VHF
I do not use the HUB
I want the PL active on Rx all the time unless I press the monitor button.
Even during scan. I have RF noise on the channel.
How do I set up on CPS?
(HUB defeats scan unchecked)
(Carrier Detect checked in Conventional)
(PLs are programmed in Zone channel assignment)
What else am i missing ?
Still getting noise Even with Sq turned all the way up

If you send me your .cpg file, I'll be more than happy to take a peek at it. If the Scan is turned off, are you still getting the noise or the CSQ traffic? Is it possible that you are hearing a distant/weak signal with the same PL tone?

 

[prcguy]

I put a ground jumper to the HUB in all my mics so I never have a problem going into carrier sq unless I press mon.

 

[nokones]

Just checking to confirm, In the "Conventional" off the main root path, not the "Scan Configuration" in the "Scan", In the "Conventional Configuration". In the "General" tab section, do you have the "HUB Defeats PL" box unchecked?

 

[nhfdcadet]

Conventional, conventional configuration, HUB defeats PL.