The title in short describes the problem. I have a lot of 2500s that I am programming and would like the decoding function of QCII to alert and open the channel when dispatched.
I have set the QCII list as the correct A/B dispatch tones. I tested the tones with another XTS2500 and the tones alerted on the radio and opened the channel as it is supposed to function. However, I also have an HT1250 handy and tested the tone set through its paging function with identical QCII call set up and it did not alert and/or open the channel. Finally, I had dispatch set off their set of tones which alerted on the HT1250 with QCII decode but did not alert on the XTS2500s.
Have I missed a crucial piece of programming or is it the XTS2500s?
I have set the QCII list as the correct A/B dispatch tones. I tested the tones with another XTS2500 and the tones alerted on the radio and opened the channel as it is supposed to function. However, I also have an HT1250 handy and tested the tone set through its paging function with identical QCII call set up and it did not alert and/or open the channel. Finally, I had dispatch set off their set of tones which alerted on the HT1250 with QCII decode but did not alert on the XTS2500s.
Have I missed a crucial piece of programming or is it the XTS2500s?