Since upgrading my BCD436HP to the latest firmware 1.11.31, the analyze and discover functions have become completely unusable and cause the scanner to locked and I must remover the batteries in order to recovery; has anyone else seen these issues?
What steps exactly are you doing to hang the scanner? What settings are you using in your analyze discovery sessions? If you use the wrong discovery settings, the scanner will hang on frequencies that have continuous broadcasts, like P25 repeater control channels.
Definitely sounds like a card problem if you can't change the settings. They are cheap, have some spares.
What settings are you using in your analyze discovery sessions? If you use the wrong discovery settings, the scanner will hang on frequencies that have continuous broadcasts, like P25 repeater control channels.
I can't even change any of the settings; I'm using the same programming I've had for over two years, I go into analyze like I always gave when traveling to new areas of the state and as soon as I select that, the entire interface is locked up and a battery pull is required. Same goes for discovery.
Definitely sounds like a card problem if you can't change the settings. They are cheap, have some spares.
Also, with the DMR upgrade, the ability to tune to a P25 control channel and see SysID, site and TG info was lost.
Sent from my SM-G935V using Tapatalk
The good SD cards cost more than $5, and it's worth not getting the cheapest card you can find when it is a critical component. I've run 436s for years and have not had card issues because I don't buy the cheapest cards.
Also, with the DMR upgrade, the ability to tune to a P25 control channel and see SysID, site and TG info was lost.
Sent from my SM-G935V using Tapatalk
Are you 100% positive about that? I'm almost positive they never did that.
Also, with the DMR upgrade, the ability to tune to a P25 control channel and see SysID, site and TG info was lost.
Sent from my SM-G935V using Tapatalk