LTR-Analyzer popping

[DaveNF2G]

I get a "pop" in my speaker whenever LTR-Analyzer sees "ATB" in a decoded OSW.

 

[slicerwizard]

[Help]

Active keys:

g/G: Adjust audio gain [is 1.00x]
I: Toggle Invalid OSW display mode [is ON]
s/S: Show normal/full stats
R: Reset stats
Q: Toggle quiet mode [QM is OFF]
Esc: End program

 

[DaveNF2G]

OK, thanks, now I can prevent it.

I am curious, though, as to why it happens.

 

[mtindor]

OK, thanks, now I can prevent it.

I am curious, though, as to why it happens.

ATB = All Trunks Busy

So it happens when there aren't any free channels for a conversation.

Mike

 

[DaveNF2G]

Yes, thank you. What I meant was why there is a sound in my speaker when LTR-Analyzer does not provide for monitoring of audio. Does it have a set of alerts for certain conditions?

 

[mtindor]

Yes, thank you. What I meant was why there is a sound in my speaker when LTR-Analyzer does not provide for monitoring of audio. Does it have a set of alerts for certain conditions?

I don't remember all of the things it might make a noise for. But I think it's not much different than Trunk88 in that respect. Both will make noises through a PC speaker depending upon what is happening, and if you have them set to make noise.

Mike

 

[slicerwizard]

If only it came with some docs that covered stuff like that.


Whenever an ATB condition is seen, the program generates an audible alert.
You can suppress this alert by turning on Quiet Mode (press 'Q' to toggle it)