Coolant113
Member
I am going to replace my existing coaxial wire with a single lay of LMR 400 with a N connector on both ends of it. My question is when i go to hook this up to the F connector on my ST-2 antenna, should i cut the N off of the wire and replace it with a F connector, or should i use an adapter? Also wondering if i should use an adaptor on the end going into my BNC splitter or cut the N off and replace it with a BNC connector. Im laying about 75ft of wire and i want to eliminate loss on both ends as much as possible. Any information on this is greatly appreciated.
Also looking into the best way to cut the ends off and replace them if it is needed.
Also looking into the best way to cut the ends off and replace them if it is needed.