ACPO-P25 VHF with Pro 2096 Wayne Co.

[n4grt]

I have been having problems trying to get the Pro 2096 to trunk the frequencies for Wayne Countys new system. If I leave the frequenices in FM mode except the CC, I hear the voice ok, just will not trunk track the frequencies. I loaded the frequencies with Win96, just doesn't seem to work. I thanks there is more I need to enter to trunk the VHF. I have asked for help on the Radio Shack forum, but so far haven't found the solution. One did say that maybe I should post hear and someone may have the anwser. I run Pro96Com and got these figures.


ID S Base Spacing T X Offset A/C Bandwidth
00 1 151,185000 0.00250 0.00000 C 0.01250

 

[KC4YIN]

I don't have that scanner but try entering the control channels and setting the mode to (P-25) Auto. That should do it.

 

[n4grt]

Thanks for replying to my problem. That call sign sounds familar. I had a guy on the radio shack forum help me out. I got it going now. It was kind of complicated because of the p25 vhf and the steps they are using. 73's

 

[bl86]

PRO-2096 Setup for Wayne System

Hello N4GRT,

Could you please let me know the Base Freq, Spacing and Offset you used for the PRO-2096 on the Wayne County System. I'm having a time getting my 2096 setup as well. Do you know if it will work setting it up with only one table or does it need more?

Thanks!

Brian

 

[whitehelmet1202]

N4GRT,

Glad to see you on the forums here. I'm a ham from Wayne County. I had problems getting my PSR-600 to track the wayne county system a few weeks ago when I visited.

I even remember your old ham callsign.....

 

[dste]

ID S Base Spacing T X Offset A/C Bandwidth
00 1 151,185000 0.00250 0.00000 C 0.01250

This means you need to set up a table

Base 151.185
Step 2.5 Khz
Lo 0 High 4095 Offset 0

You must use a recent version of WIN96 software to set the 2.5 step.

Good luck