Backlight setting-800

[Kel]

Setting up my unit using the EZ Scan software,what is the setting I use to just have the backlight come when there is a transmission,I saw some settings on the General tab but am a little confused if I set on,stealth,etc,any advise would be appreciated,there a link on this thread but can't seem to figure out.

 

[VE3RADIO]

Setting up my unit using the EZ Scan software,what is the setting I use to just have the backlight come when there is a transmission,I saw some settings on the General tab but am a little confused if I set on,stealth,etc,any advise would be appreciated,there a link on this thread but can't seem to figure out.

Set it to Leave - On in the talkgroup settings and that will cause the light to come on when the disired talkgroup is active.

 

[troymail]

Set it to Leave - On in the talkgroup settings and that will cause the light to come on when the disired talkgroup is active.

Leave? I set all mine to On to make the backlight come on upon TG transmission

 

[Kel]

Do you have to set everyone to on manually?Thats a lot of time.On my friends radio his light stays on all the time I presume he has not set it up right he did not use the software.

 

[troymail]

Do you have to set everyone to on manually?Thats a lot of time.On my friends radio his light stays on all the time I presume he has not set it up right he did not use the software.

Using the software you can select all TGs at set them to On/Leave all at the same time