I'm using DSD+ FL and when I start FMP24 with -n2 and also make sure it is toggled to NF2 before (and during) scanning, it will automatically switch to NF1 whilst scanning. Even if you switch it back to NF2 it will switch back to NF1 again once the frequency changes. There are some exceptions and sometimes the window title does not match the filter but most of the time it seems to stick to NF1. Is this a known issue and is there any way to fix/over-ride this behavior please?
I am on the latest versions of FMP and DSD and I am mainly scanning DMR UHF frequencies with an RTL-SDR dongle. The best reception in general for me seems to be with low gain and with NF2 switched on so it's very frustrating that it keeps toggling to a different filter as this introduces multiple errors. Any assistance would be greatly appreciated!
I am on the latest versions of FMP and DSD and I am mainly scanning DMR UHF frequencies with an RTL-SDR dongle. The best reception in general for me seems to be with low gain and with NF2 switched on so it's very frustrating that it keeps toggling to a different filter as this introduces multiple errors. Any assistance would be greatly appreciated!
