Hello everyone,
I'm working with someone that just purchased a IC-FR4000 for business use. I am trying to get the CWID set-up properly for them to ID at 15 minute intervals per FCC rule. I have it set-up how I think it should be set-up but I am having no success with the repeater ID'ing at all. Below is what I currently have set-up in the software;
"COMMON 3" tab;
RPT Log:
IN Delay Timer: 0.150 - (I assume this is in minutes?)
OFF Delay Timer: 0.000
IN/OFF Interval Timer: OFF
ID OUT during RPT Activation (NOT CHECKED)
C. TONE during ID out (CHECKED)
"EXPERT 1" tab;
CW ID
Dot Period: 0.050
Tone Frequency (Hz): 1000.0
Code: xxxxxxx (My clients FCC ID)
"Memory CH" tab;
RPT Log: PWR ON
RPT Log ID: CW ID
I would like the repeater to ID every 15 minutes, and NOT ID during repeater use.
Any help would be greatly appreciated!
I'm working with someone that just purchased a IC-FR4000 for business use. I am trying to get the CWID set-up properly for them to ID at 15 minute intervals per FCC rule. I have it set-up how I think it should be set-up but I am having no success with the repeater ID'ing at all. Below is what I currently have set-up in the software;
"COMMON 3" tab;
RPT Log:
IN Delay Timer: 0.150 - (I assume this is in minutes?)
OFF Delay Timer: 0.000
IN/OFF Interval Timer: OFF
ID OUT during RPT Activation (NOT CHECKED)
C. TONE during ID out (CHECKED)
"EXPERT 1" tab;
CW ID
Dot Period: 0.050
Tone Frequency (Hz): 1000.0
Code: xxxxxxx (My clients FCC ID)
"Memory CH" tab;
RPT Log: PWR ON
RPT Log ID: CW ID
I would like the repeater to ID every 15 minutes, and NOT ID during repeater use.
Any help would be greatly appreciated!