Need help with rigblaster interface software

[unioner101]

I am trying to connect my rigblaster to a CDM1250. I have ensured proper pin layout w/ my RJ45 cable, however I cannot get the computer to link with the rigblaster. According to device manager, the rigblaster (through the serial to usb cable) is assigned to com port 8. However, with the rigblaster provided WinPSK software, com port 8 is grayed out and un-selectable. Also with the echostation software it gives me an error message that there is no connection. I have re-installed the drivers several time.

I was wondering if anyone has had any similar issues or have any ideas.

Thanks

 

[ka3jjz]

What is a CDM1250? If it isn't a software defined radio then this belongs elsewhere...

best regards..Mike

 

[n5ims]

I suspect that the OP is trying to do what they asked about in this thread http://forums.radioreference.com/motorola-forum/197371-repeating-scanner-using-cdm-1250-radio.html

 

[tonsoffun]

Please do not cross post your questions, continue thread here.