Need Part for Uniden PRO-433

[SCPD]

I'm looking for the DC 13.8 volt right angle connector for the back of the Uniden PRO-433 Model. I found a substitute, but the company requires a bulk order to ship. Anyone happen to know the Uniden part # &/or if it is available? I would like to just order it from Uniden if possible. It would be awfully expensive to buy 25 of them for one radio.

TIA.

P.S. RS is no help at all.

 

[UPMan]

Uniden America does not carry parts for or support RadioShack models. You need to check with RS.

 

[SCPD]

Hmm, Well I'm SOL then.

 

[UPMan]

Unless you can find that it is used on a Uniden model.

 

[iMONITOR]

Hmm, Well I'm SOL then.

Try another Radio Shack store, or call their HQ. Some employees at the store level don't know, or don't want to be bothered. They should still be able to supply parts.

 

[sjlamb]

Or....Call GRE... they made the Pro-433 for RS: GRE America, Inc. - grecom scanner receiver, lcd modules, spread spectrum radio, wireless bridge, scanner antenna, scanner pre-amps.

 

[iMONITOR]

Even though it resembles some of the scanners made by GRE, I think the Radio Shack PRO-433 was manufactured by Uniden.

 

[Kennrth]

Found this on Wiki ! Radio front panel looks like gre but I guess not
Pro-433 - The RadioReference Wiki

Truth is these are cheap parts. So it is not worth cutting a purchase order for. Newark might have it but usually require min order $50
Hope somebody out there can help you.

 

[sjlamb]

Even though it resembles some of the scanners made by GRE, I think the Radio Shack PRO-433 was manufactured by Uniden.

Oops!! ..... wrong I was. Just goes to prove that you should NEVER trust my postings.