Pi-Star in P25 mode - network status is red for P25...

[vk2vlt]

Hello all, I need to ask for help with getting P25 mode working. Here are the settings in my pi-star below.
The pi-star is working for YSF mode and I can rx/tx on America link.
I've been watching tutorials all day and can't find anything that works so far.
When I key up my XTS3000, the pi-star doesn't respond at all.

 

[vk2vlt]

my scanner picks up the white noise on 441.200 when I key the xts3000 too.
I have about 20 TG's in my radio.
My FTM-100D works on the YSF mode.
I also changed frequencies so I'm in the correct part of the band for simplex operation.

 

[jeepsandradios]

I assume you have a valid ID in the XTS ?

 

[dmi]

my scanner picks up the white noise on 441.200 when I key the xts3000 too.
I have about 20 TG's in my radio.
My FTM-100D works on the YSF mode.
I also changed frequencies so I'm in the correct part of the band for simplex operation.

From your screenshots, the P25 service was not started and under "Network Status" it's in red.
I suggest updating the pi-star host files by going into Admin and clicking "Update".
If it's still not connecting try a different P25 Startup Host under P25 Configuration on pi-star "Configuration" page.

See if these sites help:

Amateur Radio Notes: Pi-Star

Amateur radio notes about Pi-Star configuration and use

amateurradionotes.com

P25 Reflector List - pistar.uk

www.pistar.uk

j

 

[vk2vlt]

I assume you have a valid ID in the XTS ?

I have my DMR ID in there.

 

[pointman1177]

I'm having the same issue as you, were you able to fix this? I was on my XTS 2500. Radio is transmitting, the hotspot doesn't even recognize or receive the signal. I've switched to several hosts and talkgroups.