Trunk Programing Pro-2052

[Billy_Bueno]

I am trying to set up a Pro-2052 (radioshack/uniden) for trunk scanning. I reset the scanner then selected bank 1. Entered the freq's for trunks but using the manual I cannot figure out how to enter the individual Id's to scan. The manual didn't describe this part, or I'm missing the whole thing . Any help would greatly be appreciated.
BB

 

[n3ncn]

The instructions are on page 38 of the owners manual

 

[fmon]

I am trying to set up a Pro-2052 (radioshack/uniden) for trunk scanning. I reset the scanner then selected bank 1. Entered the freq's for trunks but using the manual I cannot figure out how to enter the individual Id's to scan. The manual didn't describe this part, or I'm missing the whole thing . Any help would greatly be appreciated.
BB

Welcome to the forum.

You need to set the bank to the correct trunk mode first. A programming shortcut can be found by clicking on Wiki->Radio Shack Scanners->Pro-2052 then scroll down to Programming Shortcut Pro-2052. However, the suggestion by Mark is the best way to get familiar with the scanner.

 

[rpowley]

This previous thread may help.

 

[Billy_Bueno]

Thank you fmon, That's what I'm loking for